PTFE / Teflon PCB
PTFE PCB
Ultra-Low Loss. Any Quantity.
Six PTFE substrate options from Dk 2.20 to 3.50. For mmWave, satellite, radar, and precision RF applications where Rogers isn't low-loss enough.
[ Photo: PTFE substrate sheet + finished RF board ]
PTFE Substrates Available
All verified stock. Availability confirmed before order acceptance.
| Substrate | Dk | Df | Typical Application |
|---|---|---|---|
| F4BM220 (Dk 2.20) | 2.20 | 0.0008 | Lowest loss. Satellite transponders, phased arrays. |
| F4BM255 (Dk 2.55) | 2.55 | 0.0015 | Automotive radar 77GHz, 5G antenna arrays. |
| F4BME220 | 2.20 | 0.0009 | Woven glass reinforced. Better dimensional stability. |
| S7136H (Dk 2.20) | 2.20 | 0.0013 | Cost-effective PTFE. Volume production. |
| WL-CT338 (Dk 3.38) | 3.38 | 0.0025 | Higher Dk for size reduction. Patch antennas. |
| F4BM350 (Dk 3.50) | 3.50 | 0.0028 | Compact RF designs. Filter networks. |
[ Photo: PTFE board drilling / fabrication ]
[ Photo: finished PTFE RF boards ]
PTFE Requires Specialized Processing
PTFE (Teflon) is notoriously difficult to fabricate. The material resists adhesion, drills differently from FR-4, and requires plasma treatment for plated through-holes.
Our factory partners have dedicated PTFE production lines with sodium etch, plasma desmear, and controlled lamination processes specifically for fluoropolymer substrates.
This is why we don't just accept any PTFE order — we verify fabrication feasibility based on your specific substrate choice, copper weight, and via requirements before confirming.
PTFE PCB Examples
[ 77GHz radar antenna on PTFE ]
[ Satellite communication board ]
[ PTFE + FR-4 hybrid stackup ]
[ Material CoC certificate ]
FAQs
PTFE PCB Questions
When should I use PTFE instead of Rogers?
When you need Df below 0.002 (Rogers RO4350B is 0.0037). PTFE substrates offer the lowest dielectric loss available — essential for mmWave (>40GHz), satellite, and precision measurement applications.
Is PTFE more expensive than Rogers?
Comparable or slightly higher, depending on the substrate. The main cost difference comes from specialized processing (plasma, sodium etch) rather than raw material cost.
Can you do hybrid PTFE + FR-4?
Yes. PTFE signal layers with FR-4 structural/power layers. This reduces cost while keeping RF performance where needed. Requires careful thermal management during lamination.
What is the lead time for PTFE boards?
10-14 days typical, depending on substrate availability. We check stock before confirming. Common substrates (F4BM220, F4BME220) usually ship faster.
What is the minimum order for PTFE PCB?
One piece. We do not require minimum quantities even for exotic PTFE substrates. Material is cut from stock sheets per order.
Need PTFE / Teflon PCB?
6 substrate options from Dk 2.2 to 3.5. 1-piece MOQ. Material certification included.